Search results

my acceleration is set to 4 and i have tried anywhere from 5 cm/sec to 50 cm/sec, no difference. when i use registration marks i set them at 18" apart. down the sides. so anywhere from 4-8 per side.

So I mainly do snowmobile and dirt bike graphics. I use a 6 mil vinyl and a 10 mil lam. It doesn't matter if I use registration marks or not, my cuts will start out spot on and by the end of the cuts and be off by 3/4", it's like the heavy material doesn't feed at the correct speed or the excess...

any help would be appreciated.

if he is willing to pay, you should try Substance Inc X1 for the vinyl and i like to use avery 1360 laminate on them, super sticky and the lam gives it a really nice gloss. will stick in almost any condition, i have put large stickers on in sub zero temps. it gets kinda brittle but still stuck...

What type of material or fabrics are the ez up tents made of? I would like to print and make my own cover for my tents. Anything singular that may work would be fine and all help is greatly appreciated

Do I use the gloss or matte? Do I need to laminate with anything and what about the edge holder things? Is the 63" to wide?

What is everyone using for banner material on the l25500. I have been doing vehicle wraps for about 4 years now and would like to get setup to do banners. Any help or suggestions on equiptment, tools or knowledge would be greatly appreciated

any help is greatly appreciated

does anyone know the two fonts on here?

can't get ahold of the company to get the logo so i will have to draw it. anyone know these?

PM sent

Here are the samples. (I hope the pictures show up) the ones labeled 1 is opening the file as the pdf in the rip software and turning all ICC profiles off (colors look amazing to me). The colors labeled 2 are the same pdf with running the rip colors as normal. The number 3 samples are...

Dang that's what I was afraid of. With having to upgrade to production house and getting a spectrometer I would be several thousand dollars. Sounds like I may just have my equiptment for sale and call it quits. Thanks for all your help though at least we know the issue

Okay I printed a sample from photoshop and it's alot closer but actually a bit dark on the blues now. What should be my next step?

QUOTE=Castek Resources;1263809]The place to start is to disable color management for a CMYK-based job such as the file that is attached. It is important that you turn off all color management in the Preflight module (see attached image). The purpose of this test is to isolate whether your issue...

I am using poster shop onyx 10.1. I have tried using the profiles from hp as well as ones from the vinyl companies. I have also tried different ICC profiles that the place I bought my equiptment from recommended and some are slightly different but sd till all very close to the same. All washed...

So I have been fighting this for some time now. I tried re calibrating it and the calibration page printed the most beautiful blue but when I try just printing it won't print anything near what a true cyan or what that calibration sheet printed as. Where do I begin? Is it ICC profiles even...