• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

Search results

  1. Bi-directional printing suddenly stops

    Hi there, we're running a Mimaki JV33 with a brand new configured Main PCB board. It prints well for a few meters and then suddenly the bi-directional printing drops out. See attached photos, the print should be dark green but you can see the print fading out as the ink is only laid down in one...

  3. Mimaki JV33 - y motor error overcurrent y:peak

    Evening all - after a paper jam our Mimaki JV33-160 is showing a ’error 43 - y motor overprint : peak´ error message. Does anyone know what that means exactly and what makes it different from the ‘:ave’ error which I’ve found references to? I‘ve swapped the y motor with one from an identical...

  4. Mimaki JV33 print head repair

    Hello all! Was just wondering if anyone knows if it's possible to repair print heads? We have a print head (M007947) with a broken wall between one of the black and yellow channels. We've replaced it and I'm a little reluctant to just throw it away if a company somewhere in the world can repair...

  5. JV33-160 - black creeping into the yellow

    Hello all, I've got a very frustrating problem with both our Mimaki JV33-160 printers. Have a look a the test print result below, there are very fine traces of black ink at the top and bottom of the yellow blocks: Which unfortunately cause massive problems when printing - big thick horizontal...

  6. Printing/ink advice

    Hi there, I'm new to the forum so first of all 'hi' to everyone. I'm looking for some advice on Mimaki printers and sublimation, specifically sublimation for heat pressing/injection on sports textile and I have a few questions: - What are the most adapted Mimaki printers for sublimation...
Top