Search results

Thank you very much comprehensive reply. My wife found a way to reduce the size of the corner marks thus moving them closer to the design. That brought it under the 11.8 inches and we could print the 10 inch design. The problem was the corner marks. The problem is that her graphtec cutter has at...

The design itself is 10X14. The Crop marks "may" be outside the 11.8 inches. Could that be the problem? If so, is there a way to adjust the crop marks closer to the image so it is withing the 11.8 inches [in Flexi 12]?

Yes it was created in Flexi and has a compound. Do the crop marks have anything to do with it?? I’m using a graphtec as the plotter

I am trying to print a 10X14 design from flexi 12 to gerber edge 2. It will not print the job. It is rotated and if I reduce the size from 10 to 9.5, it will print. The 10 inches is critical. What am I doing wrong. If I reset it to 10, i get a data error 14 which means it is wider than the...

It is giving a data error 14 now. She says she did the rotation and there are no panels. Now, the properties is stuck and she can't make any changes.

I'm not familiar with is it "set to panel in some way." Forgive me, I am new to flexi.

Can anyone help me. I have created a 10" x13" decal on Flexi 12, however when sending to gerberedge 2, the decal is spliced. In need of suggestions

I’m trying to Print spot colors using fLexi 12 to a Gerber edge 2. Right now, it is only printing process of colors. Are there any suggestions?