Search results

I've had a couple go like this and both times it's been the heater relay board.

I had a similar problem on an SP-300V recently. It was a relatively new scan motor so I doubted that was the problem. In the end after disconnecting the cut carriage from the print carriage and disconnecting the scan motor gears I found the cut carriage motion was smooth across the entire...

Completely agree. I've run three SP-300V's for close to 15 years on a narrow width media so lots of scan movement and only get about 12 months out of a ribbon. Interesting thing we've noticed is when the cable's close to failing one of the cable strands gets a magenta stain close to where the...

I got my 1st Roland SP-300V about 17 years ago and it still runs day and night along with another 2 beside it as well as a couple of Roland VS-300i's. I purchased a Mimaki UCJV300-75 about 2 years ago and had it set up with CMYK, dual white and dual clear LUS-170 inks. It's nearly brought my...

I'm running a UCJV300-75 with LUS-170 white and have no problems, it's a good clean white with, in some lighting, a slightly cream cast but quite 'clean' irrespective. I'm picking up label work for white on clear prints that were initially run on other digital systems where the white was too...