• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

Search results

  1.

    problem mutoh 1324

    Have you tried performing a bidi calibration and PF calibration?

  3. 1324X INK END

    Try cleaning the smart card reader inside the cartridges housing. Take a q tip with some iso alcohol and clean it, let it dry for a few minutes. Also, clean the smart cards with alcohol as well. Good luck!

  4. Question program to minimze pixelation?

    This is the way!

  5. 2022 Ford Maverick Vehicle Template Needed

    When I need very specif templates from a specific vehicle, I always use this website. Pretty accurate at 1:25 scale. I hope this work for you! https://www.vector-templates.com/templates/show/ford_maverick_xlt/22542/

  6. graphtec 8600 cutting problems

    Graphtec hates this little trick, but it can save you from spending extra money on cutting strips. Begin by removing the old strip and cleaning any residual glue with isopropyl alcohol.(Take your time and don't rush this step, make sure to have a glue free surface to avoid any issue after...
  7.

    Need Help Graphtec Not Cutting in some areas deep enough but can cut deep enough in some.

    I learned this trick the hard way when I got stuck with a large order on a weekend and had no extra cutting strip on hand. Since then, I haven't encountered any issues with uneven cuts, ghost cutting lines, or weeding issues. Another recommendation is to learn how to set your blade pressure...

  8. Looking for Graphtec FC8600-160

    I'm looking for a Graphtec FC8600-160 (64 inches ) vinyl cutter. Info@impressautostyling.com
Top