I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes.
Click to Support Signs101 ...
What I do is trick the printer into thinking it has a full roll on it. I load a roll of Magnetic material on the back bus leave it completely rolled up. I then put a piece of transfer tape over half of the sensor on the back side this causes the printer to think it has a full roll loaded. I...
Receiving error message 139 but firmware was NOT updated at the time the message came up. A friend helped me get it into update firmware mode and we did so. Now when I re-plug the printer in and let it run through it's cycle it get's down to between 30 and 19 seconds and stops prior to "READY"...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.