I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes.
Click to Support Signs101 ...
hello all - hoping I can get some help. When I run a design thru the plotter on the right hand side of the design it seems to be cutting perfectly fine but when the blade goes to the left hand side it doesnt cut deep enough to cut thru the vinyl. It scores a very faint line but not enough to...
Hi All,
My first test I used 70-micron Vinyl. Using a 60° blade, I have adjusted the blade depth, scored 2 cuts of vinyl layered over each other making sure the top layer cuts through, bottom is scored. The machine pressure is set was set at 45gf. I have adjusted the pressure for normal cuts...
Hi All,
Playing with the settings for perf cut contour.
My first test I used 70-micron Vinyl. Using a 60° blade, I have adjusted the blade depth, scored 2 cuts of vinyl layered over each other making sure the top layer cuts, bottom is scored. The machine pressure is set was set at 45gf. I...
Hello - I am really hoping someone can help me with this problem.
We use the machines for one thing only which is kiss cutting stickers on a A4 sticker sheets:
We use a cutting mat and place the A4 sticker sheet on the mat with registration marks printed on each of the four corners of the...
Hey All,
Have a Summa S2T that I absolutely love, except for when the time comes to change the blade in it. I have marks on the holder and rod to line them back up and use same number of rotations in and out to try and get it back to where it was...and for the most part this works fine.
The...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.