• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

hp latex 335

  1.

    Print Swerving - Shifting On Line - HP Latex 335

    Hi Guys, Hope you can help or offer some advice please A couple of times today, and once during the week, we had the print almost swerve off its path Our prints have an equal gutter on each side of the print The roll remains straight, it is not unwound uneven, but for some reason the print...
    • J4cko
    • Thread
    • hp latex hp latex 300 series hp latex 315 hp latex 330 hp latex 335 latex
    • Replies: 5
    • Forum: HP Latex Printer

  2. HP Latex Window Perf Profile for Flexi

    I'm running an HP 335 with Flex 21 and need a Briteline window perf profile. I'm new to the software and our HP is not directly connected to the Internet, so I need a way to find and download profiles and then upload them over a LAN to the device. Any advice? (I've read the threads about window...

  3. which is cheaper to run? UCJV300 or HP Latex 3xx

    Hi all, I know they are completely different. Wondering if anyone own both? Really want to know which one cost more to operate and maintain especially pass the warranty period? I'm a bit scare of mimaki, I heard operational and maintenance cost is quite high. I also heard that you need to get...
  4.

    Need Help HP Latex 335 not calibrating well

    We recently acquired a fairly new Hp Latex 335. after replacing the heads and giving it a clean/tuneup we build a few profiles for it. We measure to GRACoL and compared to our 370 it wasn't calibrating as high. I have since pulled the heads and checked them, run multiple head cleans. Attempted...

  5. Summa off a little bit

    Hi all, I'm having a little problem. My summa S160D is a little bit off, it's always cutting just slightly above the print/design, most of the time. It's not like terribly off, only about 0.5mm. However, I'm doing 2 cm in diameter label so 0.5 mm is quite noticeable especially circle with...
Top