• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

mimaki cut problem

  1.

    Mimaki Cutting incorrectly

    My Mimaki is leaving these tails when cutting . I have changed the rubber pen line, the blade, & the blade case. I have changed the ADJ-PRS OFS & the over cut. I know it is not the file because it cuts perfectly on my Roland & this has been happening to every file. Recently changed the print...
    • mattkm
    • Thread
    • help mimaki mimaki mimaki 150-130 mimaki cut mimaki cut problem mimaki help rasterlink rasterlink 6 rasterlink 6 plus
    • Replies: 3
    • Forum: Mimaki
  2.

    Mimaki CG 130-SRIII Calibration

    Hello guys, I have a problem with the Mimaki CG 130-SRIII cutting plotter. I cut approximately 1 meter long sheet of vinyl foil. At the beginning, the cuts are accurate, but the further the foil moves forward, the cut seems to deviate downwards (I attach a photo). Has anyone had a similar...

  3. Signlab to Rasterlink Cut Error

    Hi there, We are running Signlab 10 and Rasterlink 5.16. We have been able to print & cut just fine up until recently. We can get everything to send from Signlab to Rasterlink and it will print like normal. When it goes to cut, we can get it to find the registration marks, but as soon as...
Top