3MIJ 180 problems

[heyskull]

We have a vehicle in to wrap a digital print over.
I have bought a roll of print and laminate and printed on our Roland RF-640.
The issue is the stick is uncontrollable and you cannot reposition the print.
It is as if the controltac property of this material has been missed out
Has anyone else had this problem lately?

Thanks

 

[signheremd]

Which version of IJ180 did you buy? There are several.

 

[heyskull]

IJ180mC​

 

[capitate]

You need to let it dry for 24 - 48 hours before laminating

 

[DL Signs]

The MC designates Micro Channels for air release. It's good for not showing any air channel lines when it's laid. Always gotta let them outgas and cure good before laminating, especially solid prints with the MC series.

 

[P Wagner]

Solvent ink acts directly on the vinyl, thinning the film. As cast SAV is already thin, the danger is that the ink can act on the adhesive, making it stickier, gummier and more aggressive. As more solvent ink is deposited, the more this is likely to occur.