70/30 Perf/vision print Curling on R-1000 - Help

[Charles@TheSignDude]

We are running econoview 70/30 Perf (vision print) on our HP Latex R-1000. For the life of me i can not get the vinyl to stop curling up BAD on the edges as it comes out. Bad enough that when i stop and it returns the vinyl back to the starting spot it is curled up enough to trip the head crash sensor.
I have tried a variety of settings. turning down the heat, turning down the air flow. Clearly what's going on is the vinyl is contracting and the paper backing is not and causing it to curl up but i have yet to find a good setting for it.
Almost wondering if the reverse would work and heat the vinyl more so that it is very playable as its curing and relax/let it stretch a bit?
Current settings we are running:

70/30 PERF (Standard)	NAME
300 dpi, 70/30 perf 8p-100-6c	COLOR MODE
	PRINTING METHOD	N/A
	HEAT SENSATIVE SUBSTRATE	no
	NUMBER OF PASSES	8
	WHITE DENSITY	N/A
	INK DENSITY (%)	100
	INK DENSITY B (%)	N/A
	OVERCOAT LEVEL	0.5
	CURING TEMP. (HEATER BAY)	141
	DRYING TEMP (PRINT ZONE)	96.4
	OPTOMIZER LEVEL	10
	SUBSTRATE ADVANCE	0
	INTER-PASS DELAY (ms)	0
	PRINTING AIRFLOW PRESSURE	30
	CURING AIRFLOW PRESSURE	400
	CURING HEIGHT	0.08
	Curing lever enabled	no

 

[Precision]

Econoview is not the best. We use Windowmark or Solvex .

Running an hp latex 360. Your profile in comparison is completely different.

I would try downloading a new ICC Profile and see the new settings.

This is usually a heat issue, but your temps seem low enough already.

 

[MGB_LE]

Have you tried rolling out media to see if curl is present in the roll itself?

 

[Charles@TheSignDude]

Have you tried rolling out media to see if curl is present in the roll itself?

Yes, the roll i nice and flat before it goes through the printer and curls bad as it s exiting after the print head.

 

[Charles@TheSignDude]

Econoview is not the best. We use Windowmark or Solvex .

Running an hp latex 360. Your profile in comparison is completely different.

I would try downloading a new ICC Profile and see the new settings.

This is usually a heat issue, but your temps seem low enough already.

Haven't found a pre-made profiles for vision print/ Pref for the R-1000 yet. Any input where to find one?

 

[balstestrat]

Have you tried to run it as heat sensitive?
Use edge holders if it helps?