• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

Acmo Display SSi

PMG

PMG

New Member
Ive ran into a problem with this font and contour cuts ....and it only happens with this font and i cant figure out why.......when i use this font in flexi and i put a outline around it then do a negative contour cut on it,the cuts are off on the x and y axis by and this is no s**t a 1/4 inch or less sometimes.my cutter is spot on with any other cut i make,,just with this font .....anybody ever run into this type of problem? :frustrated: i have a job for a customer that requires the font at least once a week...and i need to pin point this problem.
 
Last edited by a moderator:
PMG

PMG

New Member
Sorry Fred for using that stinky word:covereyes: ,,,,,,, the only thing i can think of that would be causing this issue is i was using the italic version of this font and i was reversing the italic to make it normal,,i know have the normal version and i will do a test on both italic and normal font tomorrow .....
 
M

mimirayo

New Member
Usually when I have that type of problem I look at it in lines only...sometimes they do something funky when making it. maybe you can try converting to curves to fix the problem
 
You must log in or register to reply here.
Top