Ryan J. Gill
New Member
we're printing off some film to use as a dieline - so we need pretty decent accuracy -
for testing I printed rulers going horizontally and vertically
I expected the vertical to be off, but it was actually accurate (12 inches measured to be 12 inches!)
however the horizontal ruler (24 inches) printed a little too large-- or wide (over about 16th of an inch)
any ideas on how to adjust for accuracy?
Material is 5 mil polyester (clear)
JV150-130
for testing I printed rulers going horizontally and vertically
I expected the vertical to be off, but it was actually accurate (12 inches measured to be 12 inches!)
however the horizontal ruler (24 inches) printed a little too large-- or wide (over about 16th of an inch)
any ideas on how to adjust for accuracy?
Material is 5 mil polyester (clear)
JV150-130