Hello,
I use a QE60+ Vinyl Express 24" plotter with VE LXi software. I am wondering if it's possible to have the plotter advance the material to the cutting gap on the machine when it completes a job. This way when I am ready to cut the vinyl off the roll I don not have to visually look at the vinyl, pull it forward until I see the trim line and then cut. I could just go to the machine and cut it off without thinking. I know it sounds small but I am trying to become as efficient as possible. There is an "Advance after plot" check box under the options tab of the software. I have it checked but it doesn't do exactly what I am asking here.
I use a QE60+ Vinyl Express 24" plotter with VE LXi software. I am wondering if it's possible to have the plotter advance the material to the cutting gap on the machine when it completes a job. This way when I am ready to cut the vinyl off the roll I don not have to visually look at the vinyl, pull it forward until I see the trim line and then cut. I could just go to the machine and cut it off without thinking. I know it sounds small but I am trying to become as efficient as possible. There is an "Advance after plot" check box under the options tab of the software. I have it checked but it doesn't do exactly what I am asking here.