Avery MPI 3901 non pvc vinyl

[Milo]

I’m mounting this material to polystyrene to cut on my laser. My hp365 doesn’t seem to like it very much. Has anyone used this material on a latex?

We’re printing and cutting 8,000 1” x 2” tags. The whole rolll was only 165.00 so I should Have known better.

 

[RMarshall]

I tried it in the past with our HP 560 and it was a pain – constant warping and buckling caused the printed area to scrape against the top of the curing unit.

It was a few years ago, but I think I remember cutting the roll in half in order to get it to work without the buckling issues.

 

[Milo]

Thank you for the info. That is exactly what is going on. I did figure out a solution by using the take up reel and pulling the material tight and taping it to the core.