Danny Mills
New Member
I have a serious problem as of today with my light cyan and light magenta. Started by noticing the prints were getting really fuzzy, did a test print all looks fine. I remembered how to put it in service mode so I did a fill print and the results are in the photo.
Dropbox - 20170207_191859.jpg
I did try a third party light cyan called inktec as my supplier had no genuine eco sol max. It printed fine with no problems but now it's not. The cartridge is still in at the moment but I managed to get a few prints out of an old genuine but the problem is still the same.
Any help would be much appreciated as I'm unsure what is really going on.
Thanks
Dropbox - 20170207_191859.jpg
I did try a third party light cyan called inktec as my supplier had no genuine eco sol max. It printed fine with no problems but now it's not. The cartridge is still in at the moment but I managed to get a few prints out of an old genuine but the problem is still the same.
Any help would be much appreciated as I'm unsure what is really going on.
Thanks
