Tyler Durden
New Member
Hey guys,
This is a good question for caldera but I figure I will run it by here too.
I Just installed Visualrip+ on a mac.
Im trying to get it to run my roland 545.
1.There is an IP config screen in the software that tell me to reset the ethernet switch on the roland and from there I am lost.
2. Says to complete network parameters: Mac address & IP address. Where am I supposed to get those? Ip address of what? computer or printer?
3. Says change the IP address in the Servers Administration window. Change it to what? Printers address? server/ host?
Please help if you have done this or can explain better. Its all vague to me. I do know my printers ip address
This is a good question for caldera but I figure I will run it by here too.
I Just installed Visualrip+ on a mac.
Im trying to get it to run my roland 545.
1.There is an IP config screen in the software that tell me to reset the ethernet switch on the roland and from there I am lost.
2. Says to complete network parameters: Mac address & IP address. Where am I supposed to get those? Ip address of what? computer or printer?
3. Says change the IP address in the Servers Administration window. Change it to what? Printers address? server/ host?
Please help if you have done this or can explain better. Its all vague to me. I do know my printers ip address
Last edited: