DesireeM
New Member
I'm using a fairly old Camm-1 Pro and it's been very glitchy lately. The most recent glitch is all of a sudden it's been feeding the material way too fast. I don't mean the regular speed setting though. It's cutting at its usual speed but in-between cuts, when it's moving to the next area, it feeds the material 10x faster and I keep getting a motor error. Even when I use the "Show me" pre-feed in Flexi it feeds so fast it jams right away. It does the same thing when I perform a test cut...cuts the test fine but then whips back to the origin point ridiculously fast. I've tried re-setting to defaults and turning it off/on. Any ideas? It's not the only glitch but it's the only one I can't work around.