can someone help anaiyze this test print

[bigblocktrader]

help please / had a head crash last month thought I had it fixed, did a lot of adjustments in service mode, seem to of missed somthing
SP300V

 

[Mapu]

Vertical Alignment is wrong - try to do it once more.


Look here :

http://www.signs101.com/forums/showthread.php?96360-Roland-SP300V-printhead-alignment-way-too-far

 

[bigblocktrader]

Vertical Alignment is wrong - try to do it once more.


Look here :

http://www.signs101.com/forums/showthread.php?96360-Roland-SP300V-printhead-alignment-way-too-far

working on it today will let you know

 

[J Hill Designs]

magenta might have a few missing/misdirected nozzles as well - post a nozzle test

 

[bigblocktrader]

working on it today will let you know

in service mode found vertical, test print is off a little but cant figure out how to make the adjustment.
bi directional was off some fixed that. needs some help with vertical adjustment please





m

 

[Solventinkjet]

Loosen the 3 screws that hold the head bracket down and turn the white thumb screw in the front of the head to adjust the vertical alignment. Clockwise will pull the head towards you and counter clockwise will push the head away from you. Adjust it until it lines up with the other head.

Note: Make sure you do these alignments while the head is not capped. Also, if the adjustment doesn't seem to move, you most likely have dried ink under the head bracket which acts like a glue. You will need to clean it out for the adjustment to work properly.

 

[bigblocktrader]

Loosen the 3 screws that hold the head bracket down and turn the white thumb screw in the front of the head to adjust the vertical alignment. Clockwise will pull the head towards you and counter clockwise will push the head away from you. Adjust it until it lines up with the other head.

Note: Make sure you do these alignments while the head is not capped. Also, if the adjustment doesn't seem to move, you most likely have dried ink under the head bracket which acts like a glue. You will need to clean it out for the adjustment to work properly.

Thank you, will follow up with results

 

[player]

After the manual adjustment you do the software adjustments/alignments.