I'm trying to figure out if it is possible to print on vinyl using a seperate printer, then transfer the vinyl over to the ColorCamm just to be cut out.
In the manual on paper page 46 or PDF page 48, it states how to set the base points and align points, but this appears only for when the printing is done with the ColorCamm, then the media is taken out for lamination, then reinstalled back into the ColorCamm for cutting. This not only ties up the machine in a standby state while the media is being laminated, but it also begs the question can the ColorCamm cut media that was printed on a different machine?
http://www.rolanddga.com/rnet30/files/support/pc600_user_manual.pdf
In the manual on paper page 46 or PDF page 48, it states how to set the base points and align points, but this appears only for when the printing is done with the ColorCamm, then the media is taken out for lamination, then reinstalled back into the ColorCamm for cutting. This not only ties up the machine in a standby state while the media is being laminated, but it also begs the question can the ColorCamm cut media that was printed on a different machine?
http://www.rolanddga.com/rnet30/files/support/pc600_user_manual.pdf