JAMEY
New Member
I am considering picking up another extra cutter. I was looking at the 24" CE6000 for my home office to replace a GX. I have an XC-540, GX-24, and SC at the shop and may be picking up another 54" cutter for there too but that's another story.
What I am wondering after looking at a bunch of videos is if I can set an offset (inner/outer) to the contour cut line that Graphtec Studio generates.
I am also wondering if you can set an overcut at the end of my cuts to let's say 2mm with that Graphtec Cutstudio and/or with Cutting Master 3.
What I am wondering after looking at a bunch of videos is if I can set an offset (inner/outer) to the contour cut line that Graphtec Studio generates.
I am also wondering if you can set an overcut at the end of my cuts to let's say 2mm with that Graphtec Cutstudio and/or with Cutting Master 3.