• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

changing start and end points in artpath

O

openwood

New Member
I am trying to v-grove a 12' panel that is not square.normally i change the start point to the center of the peice for better alignment.artpath is not letting me change the start point on a panel that needs to be broken up.(over 8').I am using artpath 16.does this mean i cannot change the start point on any peice over 8'. :help:
thanks

Brian :unclesam:

I have a new computer and i am going to upgrade to the current software but i must get my digital printer set up first.hopefully this will solve alot of my problems.
 
D

dennis j

Premium Subscriber
Brian, I haven't used Artpath in a long time not any help on this one when I did use Artpath I only made a couple of signs over 8' :help:
 
You must log in or register to reply here.
Top