Contour & Perf Cut on Summa

[PrinterMike]

We have a Summa 62" S3TC160 and run Flexi. We're sending a decal with a contour cut and a perf cut, managing the pressures at the Summa. When we start the job the pressures change from the presets saved on the cutter to much lower pressures. We double check the settings in Flexi production manager and there are no pressures set. Our current workaround is to have the summa pause after sets and we then change the pressures back up on the summa before it starts cutting. Any ideas?

Thanks!
Mike

 

[balstestrat]

It will come from Flexi. Check the settings in production manager as well.

 

[PrinterMike]

We were checking the pressures in Production Manager. The contour cut is set to 0 and the perf cut is set to tool 4 or 5 which is the perf cut. If we turn the perf cut off, it just runs both as contour cuts.