Cut problem...advances, then cuts??

[bighun]

Using a Roland Camm-1 CX-300, trying to find out why every file I send advances the vinyl about 2 feet before cutting?

I tried different settings in Flexi 7.6 on the panel page. Same result. Any idea?

 

[gvgraphics]

On your cut/plot screen is you "Position" set at 0.000?

 

[DRPSignsNGrafix]

also check in the print/cut manager to make sure there is no feed selection. I'm not in front of mine to look to see where it is.

 

[bighun]

Thanks for the replies guys, I'm trying to set this up for a friend. It was the setting for the production manager it was set to native, i changed it to original and it works like a charm.