Wow, you guys love the bleeding. Let me see if I can describe this better. This is a cut decal for a large wall piece that will go in every store of this retail chain in the Country. They are the pickiest people, checking everything up close before it is approved. Bleeding will not work on some of these, as I said earlier, because it has a blank white edge around the print. Normally, this is a good thing because it gives a little bit of play. However, since it is dropping about 1/16", that also means it is missing 1/16" of white border across the top. Since the border is suppose to be 1/16", the result is NO white across the top of the decal, and 1/8" of white across the bottom.....
I'm sorry I am not better at describing it, but being a corporate chain and doing concept designs for them, I am not allowed to put a picture of the decal to give you guys a better idea.
The problem can be easily fixed by nudging the cut line down about 2 notches and over 1 notch within my illy design.... the result is perfect.... i am just wanting to get rid of the need to do that... and I/m also gonna try graphtec support again cuz I was too busy yesterday afternoon to try them back....
Thanks