Need Help Cutting edge print with HS15, The actual cut is ending up short.

[Louis Pascuzzi]

Just hooked up a HS15 to my EDGE setup because my other plotter broke. The whole thing cuts but it ends up 51" long on a 53" image. The height stays correct for the whole length but the cut ends up condensed a little on the X axis. Any ideas, it's driving me nuts.
Thanks

 

[Louis Pascuzzi]

I just drew and cut an 8" square and it ended up 8" high by 7.85" long. Is there a setting I missed when I set it up?

 

[netsol]

the media is pin feed. 1 50 yd roll should be perfect.
are your belts in good shape & properly tensioned?
if you cut out 3 of the same size, are they the same?
or is there variation from cut to cut? (indicating slippage)

 

[Louis Pascuzzi]

All cuts are the same. No matter how many or what size. The belt is tensioned. The belt only controls the Y axis which is fine. It's the X axis that's off.
The error is off proportionately. If I cut an 8" box it is .15 short. On a 16" box it's .30 short.