• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

Cutting Help Needed

RaceCutter

New Member
When I cut the vinyl out and weed it, there is always one little area thats still conected on each letter .... im guessing this is where it starts/ends .... is there a setting that i can change to make it pass that start/end point to ensure it cuts the letter out fully.

Thanks, Matt
 

chopper

New Member
it depends on your equipment, cutter- software,
what you need to look at is blade offset if you have a manual for you cutter
it should tell you how to adjust it there, if not look under the hardware section here and see if your cutter is listed and see if there is a thread on your problem, if you cannot find it please list the name of the equipment you are using that will allow you to have greater success in getting an answer //chopper
 

chopper

New Member
I think mine is at .05 I would try smaller if that wont work try bigger
you may need to experiment to get it right it will also depend on your blade, let me know if that dose it
...//chopper
 
Top