ColesCreations
New Member
I suddenly have a major problem!
Purchased a few machines from another signshop that gave up, and we now have a barely used S-class 160D with OposX, and our old SummaSign Pro 160T, with Opos2, which also has very low use.
We only need one, and hardly ever need the ectra cutting width of the 160.
This of course would apply to anyone else considering upgrading from an older cutter to the newer S-class also.
I have never tried a D-cutter, as both our current and our previous ones were Tangential.
We sometimes have minor problems with Opos2 not finding markers, which we can usualy resolve.
I know the S-class has a fancy touch screen, but what's the point? All the parameters are on the computer anyway.
What is the advantage of OPOSX vs OPOS2?
Which one would YOU keep? Pros and cons of the S-class?
Purchased a few machines from another signshop that gave up, and we now have a barely used S-class 160D with OposX, and our old SummaSign Pro 160T, with Opos2, which also has very low use.
We only need one, and hardly ever need the ectra cutting width of the 160.
This of course would apply to anyone else considering upgrading from an older cutter to the newer S-class also.
I have never tried a D-cutter, as both our current and our previous ones were Tangential.
We sometimes have minor problems with Opos2 not finding markers, which we can usualy resolve.
I know the S-class has a fancy touch screen, but what's the point? All the parameters are on the computer anyway.
What is the advantage of OPOSX vs OPOS2?
Which one would YOU keep? Pros and cons of the S-class?