Slamboni
New Member
Our brand new HPL26500 is being used to print to reflective sheeting. It prints everything at 99% ish size so we have to increase every print to 101%. Is there a way to get this machine to print to size properly?
Our techno cnc router does the opposite. It adds about an eighth inch to routed blanks on one side. Is there a way to avoid this? We have recently replaced the AC inverter and the riser card.
These two issues are leading to application nightmares when fabricating MUTCD traffic signage. Any hot pro tips would be legendary at this point.
Our techno cnc router does the opposite. It adds about an eighth inch to routed blanks on one side. Is there a way to avoid this? We have recently replaced the AC inverter and the riser card.
These two issues are leading to application nightmares when fabricating MUTCD traffic signage. Any hot pro tips would be legendary at this point.