EnVision 375 Skipping on Vertical Axis?

[jfiscus]

Recently one of our plotters has been not cutting certain areas on the vertical axis.
It seems to be somewhat consistent on where, but other times it does it randomly, but it is always while the blade is traveling "up and down" the material.
We have replaced the blade, blade holder, cutting strip. Everything is clean as should be. Kinda just started out of the blue.
Any ideas?

 

[MarkH42]

Recently one of our plotters has been not cutting certain areas on the vertical axis.
It seems to be somewhat consistent on where, but other times it does it randomly, but it is always while the blade is traveling "up and down" the material.
We have replaced the blade, blade holder, cutting strip. Everything is clean as should be. Kinda just started out of the blue.
Any ideas?

We are having this exact same issue. If we try to cut, for example, 9 boxes that are 3" x 3", it will randomly cut three sides of a few boxes and not even touch the vinyl along the 4th line. I tried an older Envision that we have and replaced the carriage, but the problem didn't change, which leads me to believe it is a computer/software issue.