Hi all. I have an ongoing issue with an Epson SC80600, during a run the printer intermittently throws a "media out" error - the media will still have plenty left to print on and everything setup as per manufacturers instructions etc.
I have sometimes found that the media has spooled off the media feeder and is therefore "loose" at the back.
N
ow a new media holder has been fitted and this has obviously not solved the problem.
Also the end of roll sensor has been covered - following engineers advice so it should never throw the error - but does!
Has anyone else had this problem and any solutions would be appreciated. Cheers, Danny.
I have sometimes found that the media has spooled off the media feeder and is therefore "loose" at the back.
N
ow a new media holder has been fitted and this has obviously not solved the problem.
Also the end of roll sensor has been covered - following engineers advice so it should never throw the error - but does!
Has anyone else had this problem and any solutions would be appreciated. Cheers, Danny.
