• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

FEED MOTOR ERROR 00cc 0004

Michael Snook

New Member
Hello,
I have this error on my Roland VS640.
FEED MOTOR ERROR 00cc 0004

This may sound stupid, but do I just need a new Feed Motor?

Thank you.
 

netsol

Active Member
you are not really giving enough information

does the media advance when you press the arrows?
does it make an odd noise?
does the error come up every time?

i get that error if i reach end of roll & am not paying attention
i assume you are powered up, media loaded, have setup medial
when you press "test print" i would expect the carriage to move (enough to print nozzle check) return to home then advance media A LITTLE BIT then the head would move again

when in that sequence does the error happen?
 

Michael Snook

New Member
Hello, the error code comes up when I start the machine, I can do nothing with it apart from turn it back off as the error says.

Thank you.
 

netsol

Active Member
you may need to wait till all the fuses are in.
i would think the startup pulses the motor,, moving a fraction of an inch & looks for a pulse from some sort of sensor with a wheel
 

Michael Snook

New Member
you may need to wait till all the fuses are in.
i would think the startup pulses the motor,, moving a fraction of an inch & looks for a pulse from some sort of sensor with a wheel
Thank you. I will wait for the proper fuses and go from there.
 
Top