mbarden
New Member
Hi Folks,
We are trying to print some small flex faces in house on our Rolan VS-540. We are using Versaworks and printing on Arlon 390 Flex Face Material. The first side prints just fine at the correct dimensions. When we turn the material over to print the reverse mirrir image it seems as though the print gets smaller length wise. Our registration is dead on at the begining of the print but very soon after the print does not match the other side. Does anyone have any insight?
Thank You.
Mike Barden
Big River Sign Co.
We are trying to print some small flex faces in house on our Rolan VS-540. We are using Versaworks and printing on Arlon 390 Flex Face Material. The first side prints just fine at the correct dimensions. When we turn the material over to print the reverse mirrir image it seems as though the print gets smaller length wise. Our registration is dead on at the begining of the print but very soon after the print does not match the other side. Does anyone have any insight?
Thank You.
Mike Barden
Big River Sign Co.