HIGHSPEEDGRAPHIX
Rog
Hi, I have just upgraded from Flexi 7 and Signlab 9 to Flexi 12.....I have my Graphtec 7000-130 set to GPGL and communicating but i have to manually change the "scale" to "4" in the plotter menu settings every-time...
I see there is an output size compensation but not able to figure out how to get the settings to work....
Test Size - 12" - Measured Size 3" - Compensation scale of 4
CHECKED - Enable output size compensation.
Any ideas what Im missing or doing wrong here?
Thanks,
Roger
I see there is an output size compensation but not able to figure out how to get the settings to work....
Test Size - 12" - Measured Size 3" - Compensation scale of 4
CHECKED - Enable output size compensation.
Any ideas what Im missing or doing wrong here?
Thanks,
Roger