Flexi 7.5 Update

[Finishline Signs]

Does anyone know where I can get the updated drivers for Flexi 7.5? I just got a older from a sign shop that closed down and want to use it for my cutter but it doesn't have the drivers for the FC7000 graphtecs. I checked SAI but I only found updates for 8.0. Just thought I would check here before emailing them.

Thanks

 

[P Wagner]

I know that the 7.6x version of Flexi has the drivers for the Graphtec FC7000 plotters, and that the upgrade to 7.6 is a free update from Flexi 7.5. Anything newer (higher) than 7.6x will have a cost associated with the upgrade.

For what it's worth, you should also be able to drive the FC7000 in 7.5 by configuring the software to use the Graphtec FC5100 driver.

Bob

 

[Finishline Signs]

Thanks I will try that. I thought that 7.6 would have the drivers I need but can't find them on SAI's website. Wanted to try something else before I contact them. Everyone says they are slow the respond and I saw in another thread earlier that they were in the process of relocating at this time. I will try the other cutter and see if that will work.