Flexi 8.6v2 multiple contour cuts?

[TCC]

Has anyone managed to get the perf cut to work on a graphtec cutter out of Flexi 8.6v2 yet? I can not seem to get it to work, I can get to cut lines set to 2 conditions until I send the job then they will default to fast cut. Not sure what I am doing wrong! Any body have ideas? Thanks in advance! Oh print to a Mimaki and cutting on a FC8000.

 

[Charlie J]

I have not done it either. I've also managed to assign the two cut conditions.

This video may help tho.
http://graphtecamerica.com/FAQs/setup_FC8000_perf-cut.html


I'm using the fc 7000

 

[TCC]

I am begining to think it will not work with the Graphtec cutters. It works in Cutting Master which looks like it was made by Flexi, but I sure would like to be able to so this right out of Flexi. I guess I will keep playing with it and see what happens. Thanks!