Hello everyone,
I’m hoping someone here can help me out. I have a issue with my plotter not fully finishing a cut. It seams it doesn’t completely run through the last part of the cut.
As you can see in the image a small final part is left uncut. I’ve tried changing the blade offset but this doesn’t really change anything. I blew out the knife holder as well but also no luck.
The cut ends at the part where it’s uncut. So it seems like it just doesnt run far enough to actually finish the cut. Does anyone know what could be the cause for this?
I’m using easy cut studio
I’m hoping someone here can help me out. I have a issue with my plotter not fully finishing a cut. It seams it doesn’t completely run through the last part of the cut.
As you can see in the image a small final part is left uncut. I’ve tried changing the blade offset but this doesn’t really change anything. I blew out the knife holder as well but also no luck.
The cut ends at the part where it’s uncut. So it seems like it just doesnt run far enough to actually finish the cut. Does anyone know what could be the cause for this?
I’m using easy cut studio
