• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

gerber omega 6 and summa D160

bigben

bigben

New Member
Since my envision cutter is dead, I want to use my summa cutter for my edge printing job. The problem is when I send the job to the cutter, it read the marks and then nothing like if the job was done. I'm new to the omega software and I'm sure I've forgot something stupid. Can anybody could help me?

Thanks.
 
bigben

bigben

New Member
OK, I know this topic is old but I've found a solution. For some reason, the only way my summa will cut the job via omega is if ''summa cutter control'' is open. They don't ''talk'' to each other, but it's the only way I've been able to send jobs.
 
You must log in or register to reply here.
Top