• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

Going from X6 to 2018- Cutting Master 4 not recognizing 2018

3

3DsSigns

New Member
I recently had to upgrade my CorelDraw X6. I was able to purchase CorelDraw 2018. I did this based off of the forums here saying that was the most stable version. I've installed and it's working fine except, when I try to sent to my Cutting Master 4 software, I get error message "Running CorelDraw Not Found". Any ideas what I need to do?
 
C

ChaseO

Premium Subscriber
I have X6 and 2018 as well and if you are bouncing back and forth, cutting master gets unhappy. When I get a message like that, I close Cutting Master and both Corels, and try again with only one of the programs open.
 
C

CanuckSigns

Active Member
Did you Uninstall CM then reinstall it after you installed CD2018? CM is finniky at the best of times dont give it any excuse to mess up.
 
You must log in or register to reply here.
Top