Lophatcustoms
New Member
Hey there
I did a factory reset on my machine and managed to clear my problem, But I can't find the setting to adjust the height of the sensor when its detecting registration marks. Before the reset it was about 1/8 of inch gap from the material and found the marks without much difficulty. Now when its searching the Sensor is touching the material and I haven't managed to find one. I've looked through the manual and online and haven't been able to figure it out.
thanks
I did a factory reset on my machine and managed to clear my problem, But I can't find the setting to adjust the height of the sensor when its detecting registration marks. Before the reset it was about 1/8 of inch gap from the material and found the marks without much difficulty. Now when its searching the Sensor is touching the material and I haven't managed to find one. I've looked through the manual and online and haven't been able to figure it out.
thanks