altereddezignz
New Member
When i am contour cutting a job after it has found all the registration marks and starts to cut the job the plotter will slow way down when cutting any designs that are in line with any extended registration marks.
This is only when i am using type 2 automatic extended that places extra registration marks when doing a long run of cuts.
It will cut the speed to about half when it get to an area that is between the registration marks from left to right?
Any idea how to fix this or if there is a way?
This is only when i am using type 2 automatic extended that places extra registration marks when doing a long run of cuts.
It will cut the speed to about half when it get to an area that is between the registration marks from left to right?
Any idea how to fix this or if there is a way?