Graphtec Help!

[matthewmwarren]

Hi everyone. I'm new to the graphtec world. My predecessor set up our Graphtec to cut with the Illustrator Cut Master 4 program. I'm following his set up like before but for some reason the graphtec isn't recognizing the registration marks and it is just cutting at the edge of the page. I'm not sure if there is a setting i'm missing. I click on the cutter icon in the mastercutter settings and I see a box for use registration marks but I cannot click on it. Any help or instruction would be greatly appreciated. Thank you.

 

[matthewmwarren]

Are you sure you are running Cut Master 4, or has someone upgraded it to CM5?

I figured what I was doing wrong. I was releasing the cut via illustrator when I should've been doing it through my onyx rip cut server.