graphtec issues.............

[PMG]

on my fc7000-130 i can send a perf cut from the cutter controller perfect....when i want to send a normal cut from the controller, i pick my preset (Contour )and send the cut and it wants to pounce cut and not do a normal cut......im at my wits end on this issue i have reinstalled the firmware and the cutter controller and same issue...... i also checked in flexi to see if the stroke was a punce cut bit its set to a solid cut line, i even cleared the plotter many times as well.

 

[Neil]

I seem to remember one of the firmware upgrades changed the default line type to a pounce type.
Look in Function1/pref line type. Line type no. should = off.