• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

Graphtec plotters - inaccurate cutting line

D

desmo3

New Member
Hello, my Graphtec FC 2250 is inaccurate by 0.75-1mm when cutting by cutting marks. Each time before cutting the printed graphics, I have to manually move the cutting line 0.75mm to the right relative to the cutting marks. Is there any possibility in the machine to set this compensation to take into when cutting? Unfortunately, I did not find anything while searching. Has anyone encountered a similar problem? Thanks
 
You must log in or register to reply here.
Top