I am getting some minor banding (more noticeable in my darker colors). My head alignment setting is normally set on 4 for all 3 settings. But #1 actually is the best to where the lines are connected (not perfect but better than #4).
I still continue to get banding so my question is could it be possible that I have to go manually align the head? It use to be #4 when we first got the machine and I am using the same profile that printed great before. Did cleaning, manually cleaned the head.
Nozzles check prints all good and no nozzles are not firing. So I am thinking that it could be that my heads are not aligning correct?
I still continue to get banding so my question is could it be possible that I have to go manually align the head? It use to be #4 when we first got the machine and I am using the same profile that printed great before. Did cleaning, manually cleaned the head.
Nozzles check prints all good and no nozzles are not firing. So I am thinking that it could be that my heads are not aligning correct?
