reelguitars
New Member
I have a Graphtech FC5100-130 that has worked flawlessly for me since I got it. Today, I was gonna do a contour cut. When I powered up, the cutter head started to move back to the right...about halfway, it acted like it hit something and the power went off. I looked in the manual and it says if that happens, wait a few minutes, repower, and try again. Now, I get just a little squeak when I turn the power on and nothing more. Does anyone know if there's a type of thermal protector on the board and just where it is? I will replace or bypass it if I can find out. Thanks for your help.
David
David