Hey guys - has anyone connected Epson Edge Print Pro with Graphtec Studio 2?
I am very close, however am having issues.
When I add a cutting job to my EEP, I can add registration marks / barcodes and it creates a cut file. However, my Graphtec Studio doesn't recognize the registration marks / barcodes.
Ideally, I would like to add registration marks (not barcodes) to my prints and be able to cut them on the Graphtec. I cannot use the barcode method because I cannot set up a datalink with the Graphtec due to the fact that other computers are connected to the same plotter.
Any ideas guys?
I am very close, however am having issues.
When I add a cutting job to my EEP, I can add registration marks / barcodes and it creates a cut file. However, my Graphtec Studio doesn't recognize the registration marks / barcodes.
Ideally, I would like to add registration marks (not barcodes) to my prints and be able to cut them on the Graphtec. I cannot use the barcode method because I cannot set up a datalink with the Graphtec due to the fact that other computers are connected to the same plotter.
Any ideas guys?