I’m trying to import a cut file into OptiScout to cut on my Colex. The file shows up on screen, but it never fully loads — the mouse just keeps spinning and it doesn’t finish bringing it in.
The file contains around 900 small decals. If I break it into smaller files of 100–200 decals, it eventually loads (though it takes a few minutes).
Has anyone run into this issue or found a workaround for large batch imports? Any suggestions would be much appreciated.
The file contains around 900 small decals. If I break it into smaller files of 100–200 decals, it eventually loads (though it takes a few minutes).
Has anyone run into this issue or found a workaround for large batch imports? Any suggestions would be much appreciated.