• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

Help Needed for Roland XC-540 III

NolaSignGuy

New Member
I am getting a pinchroll error even though the pinchrolls are correctly in place. I have searched for this error and many people believe that it is the cutter cables. I currently have my machine turned off and wide open, so any advice is helpful.

TIA
 

NolaSignGuy

New Member
Actually it was the cut cables, they were a pain in the butt to replace for the first time but luckily i searched deep in this site and found step by step instructions on how to do it from a roland tech
 
Top