Hello everyone, I am having some size issues cutting vinyl with my graphtec 3000 I have figured it out finally and got some cutting done but I am having problems making large sized cuts. I am using Adobe cs5.1 and cutting master, when I send it to the plotter I have the media size at 24inx1968in for the roll of vinyl when I make the job size larger either with proportional or fit to media it will show the job size at say 22inx23in it comes out at 5.5"x5.5" every time. I have fiddled with it but I when I make it larger it cuts it in 2 different parts leaving plenty of spare room on the roll of vinyl but it is useless when it is cut in 2 parts like this. Any ideas anyone? I can make the image longer but when I reach the width of 24" it cuts it at 5.5". When I make it larger than 24" it carries over to another page.